Perform 78M6610+LMU in-system calibration

To report accurate measurement results, some level of calibration is needed. For system accuracy requirements of a few per cent, a fixed set of calibration coefficients to match the nominal gain values for a given bill of materials can be used. When requirements dictate better system accuracy than component tolerances allow, each system must go through its own calibration routine during the manufacturing process. This document walks the user through the initial configuration and calibration of the 78M6610+LMU energy measurement processor (EMP).

View the PDF document for more information.

Originally published by Maxim Integrated Products Inc. at www.maxim-ic.com as "78M6610+LMU In-System Calibration".