Global Sources
EE Times-India
Stay in touch with EE Times India
 
EE Times-India > Memory/Storage
 
 
Memory/Storage  

SLC vs MLC: Which is best for high-reliability apps?

Posted: 02 Aug 2012     Print Version  Bookmark and Share

Keywords:NAND flash  multi-level cell  single-level cell 

As with most storage technologies, NAND flash vendors are constantly being pressed to minimise cost and increase density. One way the industry has responded is by packing more than one bit in a single flash storage cell. Known as multi-level cell (MLC) memory, this technology allows for a doubling or tripling of the data density with just a small increase in the cost and size of the overall silicon. This increase in density and decrease in cost per bit does come with its own trade-offs, however, which have to be considered within the context of the application.

Industrial, military, and avionic applications impose very different demands in terms of environmental stresses, data endurance requirements, and expected usable life compared to consumer products such as USB thumb drives, memory cards for digital cameras, or even SSDs for consumer laptops and tablets. We'll examine those trade-offs, with an emphasis on how they affect the reliability of storage targeted at industrial, military and avionic applications.

Flash cell operation
Before discussing the differences between single-level cell (SLC) and MLC NAND flash, it is important to understand what makes up a flash cell. Each cell consists of a single transistor, with an additional "floating" gate that can store electrons (figure 1).

Figure 1: A basic flash cell consists of a transistor with a (floating) gate capable of storing electrons.

The cell operates as follows. For reading, the gate is electrically disconnected. The conductivity between the source and drain is then a function of the amount of charge on the floating gate. A voltage difference is set up between the drain and the source, Vd – Vs and is varied to determine the threshold voltage Vt when current flows between source and drain. The threshold voltage represents the amount of charge on the gate. A large amount of charge is used to represent logic '0,' and a small amount of charge used to represent logic '1.'

Writing is done by applying the programming voltage Vp to the gate and grounding the channel, which sets up an electric field such that electrons are attracted to the surface of the channel. Some of these collide or encounter the barrier with enough energy to tunnel through the insulating layer. These electrons are captured by the floating gate. Erasing is the opposite operation, with the gate grounded and with Vp applied to the channel to create an electric field with the opposite polarity. This attracts electrons back to the channel, many of which will have enough energy to cross the insulating barrier. This process is called Fowler-Nordheim Tunneling.

This explains one of the key challenges of flash technology—while it's easy to attract electrons to the floating gate one cell at a time, it's difficult to get them to leave. Reversing the process requires putting the channel at a voltage that could disturb adjacent cells, since the channel is common to many cells. For this reason, flash is erased in blocks, not a word or bit at a time. The blocks are sized by the flash manufacturer in order to balance silicon area (since each erase block carries a fair amount of overhead circuitry) and ease of use. Because of the logic structure of NAND flash, the flash must also be written or read in fairly large pages, typically 1 K to 4 KB. These pages are written from or read to a page buffer, from which individual byte reads or writes are done. Each erase block contains between 32 and 128 pages.

1 • 2 • 3 • 4 Next Page Last Page



Comment on "SLC vs MLC: Which is best for high-r..."
Comments:  
*  You can enter [0] more charecters.
*Verify code:
 
 
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

 

Go to top             Connect on Facebook      Follow us on Twitter      Follow us on Orkut

 
Back to Top