Global Sources
EE Times-India
Stay in touch with EE Times India
EE Times-India > Memory/Storage

Designing NAND flash controller with high-level synthesis

Posted: 09 Apr 2012     Print Version  Bookmark and Share

Keywords:High-level synthesis  electronic system-level  register transfer-level 

In addition, the compiler can automatically generate fast behavioural Verilog simulation models after scheduling to help system performance analysis and validation. The verification wrapper supported by the compiler enables synthesised RTL circuits to be verified in the Cadence Incisive SystemC environment. With this support, verification efforts can be greatly reduced.

NAND flash controllers
Flash memory has become the primary storage for portable devices, as it is more reliable and power efficient than hard disks. NAND flash requires strong error detection and correction capabilities, however. ECC blocks can be implemented in either software or hardware. If a hardware implementation is selected, it will be the most important factor in the QoR of the NAND flash controller, as ECC is an additional block and larger than the control logic part.

In this project, we implemented a NAND flash controller with an ECC block using the compiler. The design consists of four threads that include controller logic, a communications interface for AHBLite buses, and two threads for ECC blocks. Specifications include the following:

 • Support for NAND flash devices with 8- or 16bit I/O bus
 • Programmable support for various types of Micron NAND flash (table 1)
 • Programmable access timing
 • Support for 4 bits error correction per 540B
 • Support for ONFI 1.0 and AHB-Lite interface
 • The given clock period constraint is 6.2 ns

Table 1: Supported configuration of NAND flash controller.

We spent about six months from specifications to silicon—one month for SystemC coding, two months for design tuning and simple design validation, and the last three months for driver development and comprehensive HW/SW co-verification. In the next section, we will show the design process for the ECC block.

ECC implementation: BCH code
The traditional ECC for NAND flash devices includes Hamming code and BCH code, in which Hamming code only provides one bit correction. That is not sufficient for multiple-level-cell (MLC) NAND flash devices. For this reason, only BCH code is used in this design. The BCH implementation can be divided into two parts: encoder and decoder. The encoder will calculate associated parity bits for received messages and put them into spare parts of NAND flash devices. The decoding operation has three fundamental steps:
1) calculation of syndromes
2) co-efficient calculation of the error-locator polynomial
3) root calculation of the error-locator polynomial

Initial Design for HLS
It is easy to find a software implementation of BCH code in C/C++ through resources on the Internet. Designers just need to add hardware-specific SystemC constructs to the pure C/C++, and subsequently employ HLS tools to generate an optimised RTL implementation. The translation only requires a few weeks of effort even if the designers do not have related domain knowledge. During synthesis, we performed full loop unrolling for the parity and syndrome calculations to finish the calculation of each byte within one memory access time (i.e. one clock cycle). All function calls were in-lined to maximise optimisation for every thread. In addition, we had to disable resource sharing in order to finish synthesis in a reasonable amount of time.

 First Page Previous Page 1 • 2 • 3 Next Page Last Page

Comment on "Designing NAND flash controller with..."
*  You can enter [0] more charecters.
*Verify code:


Visit Asia Webinars to learn about the latest in technology and get practical design tips.


Go to top             Connect on Facebook      Follow us on Twitter      Follow us on Orkut

Back to Top