Global Sources
EE Times-India
Stay in touch with EE Times India
 
EE Times-India > Networks
 
 
Networks  

Molex 25Gb/s interconnect supports SFP+, 100GbE

Posted: 26 Apr 2012     Print Version  Bookmark and Share

Keywords:I/O connector  100 Gigabit Ethernet  cable assembly 

Molex Inc. debuts its ZXP Modular I/O Interconnect System that is available as a small form-factor pluggable (SFP) interface supporting data transmission at speeds beyond SFP+, up to and beyond 25Gb/s. The design can also support emerging protocols such as 100 Gigabit Ethernet, according to the company.

Molex ZXP Modular I/O Interconnect System

The device supports data transmission beyond SFP+ and 25Gb/s.

Fischer Huang, regional product marketing manager at Molex pointed out that a typical I/O connector at these high data rates with receptacle and plug will have several zones that are important for successful operation. The press-fit connection between the PCB and the connector, for example, can give rise to electrical stub effects. The back drilling of the plated through-holes (PTH), the ground/signal balance at signal launch, signal routing and anti-pad and via geometry are all important considerations.

A second important zone is the board-to-connector transition, the area that manages the signal's right-angle travel from the board onto the connector. Geometry disruptions can result in impedance mismatches. The connector body itself will also require careful design consideration, including the dielectric properties of the moulding material, explained Huang.

The terminal beam is one of the two most difficult areas of the connector to manage, noted Huang, and major geometry changes can again result in impedance mismatches. The geometry of the contact point is also important to reliability. The contact lead-in is important to connector functioning and determines the deflection of the beam when plug and receptacle are mated. The angle of deflection is also important in terms of insertion force. This entire area is dead electrically but can act as an electrical stub, degrading signal integrity, Huang continued.

Huang went on to underline important design considerations that arise with the paddle card, conductor termination and the strain relief area. Care also has to be taken with cable assembly performance. Designers will need to focus on frequency domain data, with an emphasis on measurement and the application of statistical analysis.

Huang also considered EMI and thermal issues. Where the connector and cage interface with the PCB, EMI can be prevented by ensuring a 360-degree seal. To optimise thermal dissipation, the connector can be designed with heat dissipating fins and the front panel should be designed to focus air flow through the fins. Molex has conducted wind tunnel testing to analyse the relationship between air flow and temperature, and the results, said Huang, drive design optimisation.





Comment on "Molex 25Gb/s interconnect supports S..."
Comments:  
*  You can enter [0] more charecters.
*Verify code:
 
 
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

 

Go to top             Connect on Facebook      Follow us on Twitter      Follow us on Orkut

 
Back to Top